Qmar - low pressure foam gun

A product with excellent performance for professional use. For application via foam gun. Reduced expansion during binding - does not warp the frames. Recommended for PVC profiles.

Application

Strong and durable fixing of window and door frames. Filling cracks, crevices and fractures in the walls, supplementing thermal insulation.

properties

• excellent adhesion to most materials used in construction,
• skin formation time up to 15min,
• setting time from 2 to 6 hours,
• high efficiency - up to 45 L.

Method of use

• Thoroughly clean and degrease the working substrate
• Before use, make sure the can is positive (optimum +20 C).
• Shake the can well (for about 30 seconds) to thoroughly mix the ingredient in.
• Screw the gun to the can, the working position for assembly is the can position "to the top".
• Apply foam from below to the gap.
• Fill the joints up to 60% deep, but not more than 5 cm per one layer, wider than 5 cm should be filled in layers,
• Moisten each layer after application with water, e.g. with a sprayer.
• Excess foam after curing should be removed mechanically (e.g. with a knife).
• After full hardening, the foam should be protected against UV rays using plaster, paints, for example.